山东通风管道已经广泛应用于各行各业中，但是随着使用时间的不断增长，山东通风管道中会积累大量的杂质。如果这些杂质将长期储存在管道中不清理的话，会在运行过程中加速其油的冷凝。如果温度转换过高，气压阀、液压等部件会损坏，严重影响正常运行。因此，定期清理通风管道设备是非常必要的。但是应该如何清理呢?今天高氏通风管道有限公司的小编将告诉您应该如何清理。
Shandong ventilation pipeline has been widely used in all walks of life, but with the continuous growth of the use of time, Shandong ventilation pipeline will accumulate a large number of impurities. If these impurities will be stored in the pipeline for a long time without cleaning, it will accelerate the condensation of oil during operation. If the temperature conversion is too high, the air pressure valve, hydraulic and other components will be damaged, seriously affecting the normal operation. Therefore, it is necessary to clean the ventilation duct equipment regularly. But how to clean it? Today, the editor of Gao's Ventilation Pipe Co., Ltd. will tell you how to clean it.
山东通风管道安装
Shandong ventilation pipeline installation
1.风管与风机连接时，进风口和出风口应安装软接头。软接头的横截面尺寸应与风机入口和出口的横截面尺寸相同。软管连接器可以由帆布、人造革和其他材料制成。软管的长度不应小于200，且紧密度应适当。软管可以缓冲风扇的振动。
1. When the air duct is connected with the fan, the air inlet and outlet should be installed with soft joints. The cross-sectional dimension of the flexible joint shall be the same as that of the fan inlet and outlet. Hose connectors can be made of canvas, synthetic leather and other materials. The length of the hose should not be less than 200 and the tightness should be appropriate. The hose can cushion the vibration of the fan.


2.输送冷凝水或含水量较大的气体时，水平管道应有坡度，并在低点与排水管连接。安装时，风管底部不应出现纵向接缝，底部接缝处应暂停密封处理。
2. When transporting condensate water or gas with large water content, the horizontal pipeline should have slope and be connected with drainage pipe at low point. During installation, the longitudinal joint should not appear at the bottom of the air duct, and the sealing treatment should be suspended at the bottom joint.
3.输送易燃易爆气体的钢板风管，应在风管的连接法兰处安装跳线，并与静电接地网连接。
3. For steel plate air duct conveying inflammable and explosive gas, jumper shall be installed at the connecting flange of air duct and connected with electrostatic grounding grid.
4.风管与除尘设备和加热设备连接时，设备安装完毕后，根据理论测绘图暂停预制安装。
4. When the air duct is connected with the dust removal equipment and heating equipment, the prefabrication and installation shall be suspended according to the theoretical mapping map after the equipment is installed.
5.在山东，安装通风管时，预制风管时应打开进出口。如果风管需要在安装结束时打开，其接口应紧密。
5. In Shandong Province, when installing the ventilation pipe, the inlet and outlet should be opened when prefabricating the air duct. If the duct needs to be opened at the end of installation, its interface should be tight.
6.当水平风道高度超过4m时，安装人员应佩戴安 全带。脚手架或移动支架上的跳板应固定好，跳板的宽度应符合安 全规范。脚手架上的设备人员应携带袋子，以免掉落物体或电钻伤人。
6. When the height of horizontal air duct exceeds 4m, the installation personnel shall wear safety belt. The springboard on the scaffold or mobile support shall be fixed, and the width of the gangway shall comply with the safety regulations. Equipment personnel on the scaffold should carry bags to avoid falling objects or electric drill from hurting people.
山东通风管道厂家
Shandong ventilation pipe manufacturer
以上就是我们山东通风管道厂家向您介绍的关于清理通风管道杂质的方法，通风管道应该每三个月清洗一次，这样不但能保证平时的正常运行，还能延长通风管道的使用寿命。大家一定要认真对待我们的设备，感谢大家的关注。
The above is our Shandong ventilation duct manufacturers introduced to you about the method of cleaning the air duct impurities, the ventilation duct should be cleaned every three months, so as not only to ensure the normal operation, but also to extend the service life of the ventilation duct. We must take our equipment seriously. Thank you for your attention. 上一篇：济南通风管道中的杂物该如何进行清理？
下一篇：济南通风管道的类型及通风管道的具体作用介绍